CHAPTER 5

Recommended Simulation Workflow

Recommended sequence of steps to prepare, execute and analyze a DEM case in BrixDEM.

The recommended flow for a new case covers the entire cycle of pre-processing to post-processing. Pre-processing steps can be executed in any order; project saving before execution is mandatory - the solver only creates the simulation from a saved project.

Pre-processing

  1. Create or open project;
  2. Set units and scale;
  3. Import or create geometry;
  4. Apply transformations and scale;
  5. Set surface movement;
  6. Create materials;
  7. Configure pairwise interactions;
  8. Create inlets/outlets;
  9. Adjust the domain;
  10. Numerical setup (Δt, gravity, backend);
  11. Configure results;
  12. Save project.

Execution and post-processing

  1. Execute simulation;
  2. Monitor console, snapshots and energy;
  3. View particles and graphs;
  4. Analyze CSVs and metrics;
  5. Export results and report.

5.1 Tutorial: minimum test case

Objective: to verify that the full flow of the software works before investing time in a real case. This tutorial is a sanity test - does not replace the physical validation of the industrial case.

  1. Create a new project in a short folder path without special characters (e.g.: C:\sims\teste);
  2. Create a Default Box in the domain (or import a simple geometry);
  3. Adjust domain with Adjust to Geometry;
  4. Create particle material in Materials;
  5. Configure the interaction between particle and wall material;
  6. Create an inlet with small flow and add it to the list (Add);
  7. In Settings, use a short end time and conservative timestep (Fixed or Rayleigh automatic);
  8. Set essential results: energy, number of particles and force/torque;
  9. Save the project and click Run;
  10. Track console, snapshots and energy while running;
  11. At the end, open 3D particles and 2D Charts to check the results.